Pull them up into the attic and then push them down to the distribution box.
Cable drop through attic.
Run the fish tape down into the outlet stud cavity through a 3 4 in.
Cut the holes that the wire will pass through to enter and exit the attic.
Mark the ends of the cables with colored electrical tape for the outlet location.
For the horizontal portion of the cable run this can involve drilling holes in the joists where the cable will pass.
Depending on what the wiring is for this may be go through the drywall to the ceiling for instance for new lighting or be farther down on a wall.
Raul no this is not a standard practice and is most likely the result of improper installation of electrical attic wiring.
When adding or replacing wiring in finished walls most electricians will attempt to make the horizontal portion of the cable run in the unfinished attic or basement crawlspace areas looping the cable down or up through the wall cavity across the floor or ceiling joists then vertically through another stud cavity to the next wall box opening.
Yes this should be corrected and it would be good to have the wiring and all the circuit connections inspected as well.
When you must deal with an attic space because you can t run the cable by simply pushing up the ceiling tiles there a few things to consider.
The attic wiring should be protected and secured to ceiling joists or other wood structural supports.
You ll need a powerful drill and either a paddle bit or a hole saw for.
I traced down the cable tv through that attic and then drilled new holes in the top plate right next to the cable tv holes.