Cable Clamp Installation

For single stamped cable clamps use the same guidelines as you would for a.

Cable clamp installation.

If the packaging recommends a torque setting for the clamps tighten until it s reached. Turn back specified amount of rope from thimble or loop. A clamp and thimble in one convenient fitting simplifies installation while providing support and fray protection to the wire rope loop. Apply u bolt over dead end of wire rope live end rests in saddle never saddle a dead horse tighten nuts evenly alternate from.

The clamps should be evenly spaced with the saddle facing up. Refer to table 1 below left in following these instructions. To install this type of clamp insert the threaded end into a knockout hole in the box then thread on the locknut onto the threaded end from inside the box. Install the thimble in the loop and place another cable clamp as close to the thimble as possible.

Crosby clamps are not to be staggered. Fist grip clips are a newer take on wire rope clips and are designed to make installation easier. No se preocupe el test no está medido en tiempo así que relájese y concéntrese en las preguntas y lo hará genial. Suerte en el test.

Again the u bolt part of the clamp must be installed over the short side and the base clamp must be on the long side of the cable. Use a torque wrench to tighten the clamp. Starting from the clamp closest to the dead end use a torque wrench to tighten each hex nut until you hear a click from the wrench. Swpeet 50pcs 304 stainless steel 6mm 16mm vinyl coated cable clamps assortment kit without rubber cushioned insulated clamp metal clamp tube holder for tube pipe or wire cord installation 3 6 out of 5 stars 11.

Tighten all the hex nuts down the line until the clamps are flush. Crosby clamps on each side 6 total clamps. Al hacer clic en el botón de una pregunta. Tighten the nuts securely.

We demonstrate the processes. Durante la prueba puede hacer clic en el botón revisar pregunta para marcar la pregunta en amarillo como un recordatorio visual para volver a visitar la pregunta antes de enviar las respuestas de la prueba. A locknut type clamp is the classic metal cable clamp with a short threaded cylinder and locknut on one end and a saddle type clamp with two screws on the other end. Never saddle a dead horse meaning the saddle of all 3 clamps should side.

Additionally never put the saddle end of the clamp on the short or dead leg of the wire rope. Wire rope compression sleeves.